Adding Snaps to a Prefold Diaper
Tutorial below provided by Jennifer
- Infant size Prefold diaper
- Pin
- Ruler or tape measure
- Piece of paper or sticky label
- Snap pliers
- 8 size 20 snap caps (with thicker fabric, long prong caps may work better)
- 6 sz 20 snap sockets (female)
- 2 sz 20 snap studs (male)
- Awl
- Pin
- Ruler or tape measure
- Piece of paper or sticky label
- Snap pliers
- 8 size 20 snap caps (with thicker fabric, long prong caps may work better)
- 6 sz 20 snap sockets (female)
- 2 sz 20 snap studs (male)
- Awl

First you will want to pick your Prefold. I am using an embellished one to help show the front and back.

Choose your front and back.

Make
your snap template. I chose to use a 1 in x 2 ¾ in rectangular label.
This way I can stick it on my diaper and it will not move while making
my holes.
Find
the middle length wise. I folded it in half. Starting at ½ cm from the
edge mark every 2cm. You will make 3 marks for 3 sockets.

Place label on diaper just under the zigzag stitching and at the very edge of the quilted part of your prefold.

Make
your holes by poking your awl through the label and diaper. Make sure
you do it all the way to the handle of the awl and kind of wiggle it. It
is a lot of fabric and you want to make sure you have a good hole to
put your cap through.

Repeat on other side of front.



Center snap in pliers and press firmly.

Repeat until you have 3 sockets on each side. Like so.

Now
for the back. Place diaper in front of you and fold in half from bottom
to top so that your socket are facing you. (see above picture)
To
place your back studs you will measure ½ " from the edge just below the
zigzag stich. Mark with pin. Make hole with awl. Again make sure to
wiggle the awl.


Place cap on the back and add socket. Center snap in pliers and press firmly.


Repeat on other side. And you are finished.


In action on my 7 month old.

No comments:
Post a Comment